Before Use; Operation - cecotec Total Iron Expert 8500 Implode Bedienungsanleitung

ENGLISH
5.Low steam rate indicator
6.Medium steam rate indicator
7.High steam rate indicator
8.Steam rate control button

3. BEFORE USE

Take the product out of the box.
Remove any packaging materials, stickers or protective foil from the soleplate.
Clean the soleplate with a soft cloth.
Fill the water tank with water and heat up the iron, and then iron over a piece of damp cloth
for several minutes for the purpose of removing any residue on the soleplate.
Warning: Some parts of the steam iron have been slightly greased and as a result, the iron
may slightly smoke when switched on for the first time. After a short time, this will cease.
It is normal that strange odor comes out from the unit for the first use. This will cease after a
short while.
When you switch on the appliance, the steam generator may produce a pumping sound. This
is completely normal; this sound indicates that the water is being pumped into the steam
generator.
During the soleplate's heating process, some steam will come out from the soleplate
automatically and this phenomenon will continue for about 3 seconds.

4. OPERATION

Water inlet cover
Open the water inlet cover and fill the water tank with water through the filling aperture.
Make sure the water does not exceed the MAX. mark on water tank.
Power switch
For switching the device on, it must be plugged in. Press the power switch button, and the
power indicator light will turn on. The low steam rate is the default mode, so its indicator light
will turn on. Press the power switch button for about two seconds and the device will turn off.
Steam rate control button
The steam rate can be selected low, medium or high by the steam rate control button.
Whichever is selected, its indicator will flash, and it will flash after having finished
preheating.
Temperature dial
TOTAL IRON 8500 IMPLODE / 9000 TURBO-BOOST 23
Total Iron 8500 Implode 9000 Turbo-Boost.indd 23 15/11/19 15:00