Residual Risk; Package Contents; Parts Description - Parkside PMSG 200 A1 Montage-, Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Introduction
It is imperative to adhere to the applica-
ble accident prevention regulations.
The device must not be used:
in insufficiently ventilated rooms,
„
in explosive environments,
„
to defrost pipes,
„
in the vicinity of people with cardiac
„
pacemakers and
in close proximity to easily
„
flammable materials.

Residual risk

Even if you operate the device as
intended, there will be residual risks.
The following dangers may occur in
connection with the build and design
of this multi-welder:
Eye injuries due to glare,
„
Touching hot parts of the device or
„
workpiece (burn injury),
In case of improper protection risk of
„
accident and fire through sparks and
slag particles,
Harmful emissions from smoke and
„
gases if there is a lack of air or
if closed rooms are insufficiently
extracted.
Reduce the residual risk by carefully
using the device as intended and
observing all instruction.
z Package contents
1 Multi-welder PMSG 200 A1
1 1.0 welding nozzle (pre-fitted,
only for solid aluminium wire)
labelling: 1.0 A
4 Welding nozzles for flux-cored
wire (1x 0.6 mm; 1x 0.8 mm;
1x 0.9 mm; 1x 1.0 mm) labelling
in accordance with the diameter:
0.6; 0.8; 0.9; 1.0
1 Chipping hammer with wire brush
64
GB/MT
1 Solid aluminium wire 200 g
(pre-fitted, 1.0 mm Ø, type:
ER5356
1 Welding mask
1 MMA electrode holder
1 Operating instructions
1 Ground terminal with cable
1 MIG torch with welding cable
1 Flux-cored wire 200 g 1.0 mm Ø,
Type: E71T-GS
Rod electrodes (2 x 1.6 mm;
5
2 x 2.0 mm; 1 x 2.5 mm)
z Parts description
Cover of the wire feed unit
1
Handle
2
Mains plug
3
Earth cable with earth terminal
4
Main switch ON/OFF
5
(incl. power indicator lamp)
Rotary switch for setting the welding
6
current
Torch nozzle
7
Torch
8
Torch button
9
Cable assembly with direct
10
connection
Welding nozzle (0.6 mm)
11
Welding nozzle (0.8 mm)
12
Welding nozzle (0.9 mm)
13
Welding nozzle (1.0 mm)
14
Solid welding wire spool (aluminium)
15
Ø 1 mm / 200 g (pre-fitted)
Flux-cored welding wire spool (steel)
16
Ø 1 mm / 200 g
Chipping hammer with wire brush
17
Feed roll
18
Shield body
19
Dark welding lens
20
Handle
21
Welding mask after fitting
22
Mounting clip
23