Master F-40 Handbuch Seite 69

You should apply the lubrication after approximately the first 40 hours of operation. We recommend lubrication
of the deck according to the following timetable:
Light use (less that 3 hours per week) every 6 months
Medium use (3-5 hours a week) every 3 months
Heavy use (more than 5 hours per week) every 6-8 weeks.
See below procedures for lubricating:
Use a soft, dry cloth to wipe the area between the belt and deck.
Spread lubricant onto the inside surface of belt and deck evenly (make sure the machine is turned off and
power is disconnected).
Periodically lubricate the front and rear rollers to keep them at there peak performance.
If the treadmill belt/deck/roller is kept reasonably clean it is possible to expect over 1200 hours before
additional re-lubing is necessary.
4.4 How to check the running mat for proper lubrication
1. Disconnect the main power supply.
2. Fold the treadmill up into the storage position.
3. Feel the back surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend you use a silicone based spray to lubricate your Lifespan Treadmill. This Can be
purchased from your local sports Retailer or a local hardware store.
4.5 Belt Adjustment
Belt Tension Adjustment-It is very important for joggers and runners in order to provide a smooth, steady
running surface. Adjustment must be made from the right and left rear roller in order to adjust tension with the
Hexagonal Wrench provided in the parts package. The adjustment bolt is located at the end of the rails as noted
in diagram below:
Left bolt
Note: Adjustment is thru the small hold on the end caps.
69
Right bolt
EN