Promac FX- 388D Bedienungsanleitung Seite 33

Adjustment
a) Use 100385 or similar PROMAC lubricate on shaft and column surface.
b) Check if the surface of the worktable is free from dust, chips or oxidization.
c) Check that the cutting tool is sharp and properly tensioned and the workpiece is securely clamped.
d) That the work spindle speed is not set too high and make sure the cutting speed the work carried
out complies.
e) Make sure that everything is ready before work.
AFTER OPERATION
a) Switch off the machine and disconnect the power.
b) Eject the tool.
c) Clean machine, bare parts, guides and spindles with a slideway PROMAC 100385 oils.
d) Cover machine with cloth to protect it from dust and dirt.
MACHINE HEAD ADJUSTMENT
a) To raise or lower the machine head, loosed the clamp bolt on the side and use the crank to move
up/down the head via the rack and pinion mechanism.
After reaching the desired height, must tighten the clamping bolt to avoid vibration.
SETTING FOR DRILLING
a) Switch the selector to the character "drill" position.
b) Set the drilling depth by depth stop.
c) You can control the feed rate for drilling by turning the cross handle.
SETTING FOR TAPPING
a) The selector to the character "Tapping" position.
b) Set the thread depth by depth stop.
c) Turn the feed handle to tap and when reaching the tapping depth, reverse the feed
handle and the spindle will reverse the rotation automatically to exit the threaded hole.
d) If desired, press reverse button before reaching the drilling depth .
33
Always wear protective glasses!