Installation; Installation Instructions; Electrical Connection - Franke DM72M Gebrauchs- Und Installationsanweisungen

Installation

Important: Installation must be carried out in compliance with the current regulations. It must be only be carried out by
specialised and licensed personnel.
Cabinet requirements
For built-in units, the components (plastic materials and veneered wood) must be assembled with heat-resistant
adhesives (max. 100°C): unsuitable materials and adhesives can result in warping and ungluing. The cabinet must allow
sufficient room for the electrical connections. The cabinet in which the oven in fitted must be strong enough to take the
weight of the equipment.
The oven must be securely installed in the recess. The oven can be installed in a column cabinet or under the top of a
modular unit, provided sufficient ventilation is guaranteed.

Installation instructions

Models (DG72M - DM72M - DM74M - GA74M - DC72M - EM74M - CM74M)
Measure the width of the shoulder (S) of the cabinet (normally 16, 18 or 20 mm).
16 mm shoulder: on each fixing bracket (F) position 2 lugs (T) marked with the number 16.
18 mm shoulder: on each fixing bracket (F) position 2 lugs (T) marked with the number 18.
20 mm shoulder: the 20 mm shoulder does not require the use of lugs.
Position the brackets (F) against the shoulder of the cabinet and at the bottom on the oven support top.
Secure the brackets (F) with the screws (V). Insert the oven in the cabinet, open the door completely, and fix it to the
brackets (F) using the 4 screws (V) and 4 plastic spacers (D).
Models (KR72M - AX72M - SUPER TECH57 - AD72M - AX76M - NE72M - KU72M)
Insert the appliance in the compartment; fix the oven to the cabinet with the 4 screws
provided, using the holes prepared in the side panels.
If the oven is to be fitted under a cooktop, firstly turn the top connection (R) to the right or left
so that the oven fits properly.

Electrical connection

FRANKE ovens are supplied with a three-core power cable with free terminals.
If the oven is permanently connected to the power supply, install a device that ensures disconnection from the power
supply, with a contact opening distance (at least 3 mm) enabling complete disconnection in category III overvoltage
conditions. Make sure:
a) the plug and socket are suitable for a 16A current
b) both can be easily reached and are positioned so that no live part is accessible when inserting or removing the plug
c) the plug can be easily inserted
d) when plugged in, the oven does not rest against the plug when installed in the cabinet
e) the terminals of two appliances are not connected to the same plug
f) a 3 x 1.5 mm
g) the connection polarities of the free terminals must be respected (Brown=Phase
Blue=Neutral Yellow/Green=Earth)
NB: Make sure the characteristics of your house electrical system (voltage, maximum power
and current) are compatible with those of your FRANKE oven.
22
Downloaded from www.Manualslib.com
2
cable type H05VV-F must be used when replacing the power cable
manuals search engine
BLU
BLUE
GIALLO-VERDE
YELLOW-GREEN
MARRONE
BROWN
L N