DeFelsko PosiTector DPM Gebrauchsanweisung Seite 15

Before returning the instrument for service...
1. Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
2. Examine the surface temperature sensor for dirt or damage.
3. If the humidity sensor is slow to respond or reading erratically,
recondition the sensor by removing the probe from the gage
body and wrapping it in a damp cloth overnight.
4. Perform a Hard Reset (pg. 4).
5. If issue is not resolved, Update (pg. 11) your PosiTector gage
body and re-attempt measurements.
IMPORTANT:
If these steps do not resolve the issue and the Gage must be
returned for service, please follow the instructions provided at
www.defelsko.com/service.
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole
or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTector, and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and
in other countries. Other brand or product names are trademarks or registered trademarks of their
respective holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.
Returning for Service
and Limited Liability
and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2020
All Rights Reserved