Herunterladen Inhalt Inhalt Diese Seite drucken

Inhaltsverzeichnis; Funktionsbeschreibung - Dantherm CD 500 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

0. Inhaltsverzeichnis

1.
2.
2.1.
2.2.
2.3.
3.
4.
5.
5.1.
5.2.
6.
Störungssuche
7.
Technische Daten
8.
Schaltplan
9.
Kältekreislauf
10.
Reserveteilliste

1. Funktionsbeschreibung

Der Luftentfeuchter CD 500 arbeitet nach dem
Kondensationsprinzip. Mittels Ventilator wird die zu
entfeuchtende Luft über einen Filter angesaugt und
ihr im dahinterliegenden Verdampfer Wärme
entzogen. Durch die Abkühlung unter den Taupunkt
kondensiert der in der Luft enthaltene Wasserdampf
auf den Verdampferlamellen zu Wassertropfen. Diese
werden in der Kondensatschale aufgefangen und zu
einem Abfluss abgeleitet. Der kalten Luft wird beim
Durchströmen des Kondensators die vorher
entzogene Wärme wieder zugeführt. Auf Grund der
freiwerdenden Verdampfungswärme und der in
Wärme umgewandelten Antriebsarbeit des
Kompressors und Ventilators, wird der Luft mehr
Energie zugeführt als ihr vorher entzogen wurde.
Diese Wärmezufuhr entspricht ungefähr einer
Temperaturerhöhung von 5°C. Durch die ständige
Zirkulation der Raumluft durch das Gerät wird die
absolute Feuchtigkeit der Luft nach und nach gesenkt,
wodurch ein sehr schnelles und schonendes
Austrocknen erreicht wird.
Downloaded from
www.Manualslib.com
Filterreinigung
Gerätereinigung
manuals search engine
0. Index
1.
Method of operation
2.
Installation of the unit
2.1.
Positioning
2.2.
Electrical connection
2.3.
Condensate drain
3.
Operation
4.
Electronic control
5.
5.1.
5.2.
6.
7.
8.
Wiring diagram
9.
Cooling circuit
10.
Spare parts list
1. Method of operation
The dehumidifier type CD 500 works in accordance
with the condensation principle. The air to be
dehumidified is taken in through a filter and the heat
is removed by an evaporator situated behind this. By
cooling the air below the dew point the water vapour
condenses on the evaporator pipes to droplets. These
droplets fall onto a condensate tray and finally to a
drain. The heat previously removed from the air is
returned to the cold dry air as it passes through the
condenser. More heat is returned to the air than was
previously extracted as a result of the latent heat and
the energy of the compressor being turned into heat
energy. This extra heat corresponds to an approximate
increase in tempera-ture of 5°C. The continuous air
circulation through the unit reduces the relative
humidity giving rapid but gentle drying.
1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis