TV SPEAKER: CENTRE
REAR SPEAKER: ON
SUBWOOFER: EXT.
VOLUME (LEFT/CENTRE/RIGHT/ LS/
RS/SUBWOOFER): Adjust the balance of
the speakers.
DELAY TIME: Adjust according to where
the speakers are placed.
Hint:
When only using an external front speaker
which is sufficiently large for the bass sound,
and also emitting the bass sound from the
front speaker,
Set SUBWOOFER to OFF. If set to anything
else, the bass sound is not emitted from the
external front speaker.
Also, when using a front speaker and
subwoofer from the same amplifier, set the
SUBWOOFER to OFF.
Adjusting the volume balance
with the TEST MODE
Use the test signal to adjust the volume level
of each speaker so that they are all the same.
Preparation:
• The TV volume cannot be adjusted after
the menu is displayed. Increase to the TV
volume level to about 10 before
displaying the menu.
1 Display the sub-menu of the
DOLBY DIGITAL/PRO LOGIC
function
2 Press the 6
6 buttons to choose
6
6
TEST MODE. Then press the 5
buttons to choose ON
Test signals are output from each of the
speakers in turn.
• The subwoofer test signal is not output.
When using the front speaker
system and/or subwoofer system
with the TV:
Turn on the power of each amplifier,
slowly increase the amplifier's volumes
until the sound emitted from each speaker
connected to the system is about the same
as that of the sound emitted from the TV
speakers. Note that increasing the
amplifier volume too high may damage
the speakers.
Stopping the test signal:
Press the 6 buttons to choose TEST
MODE and press the 5 buttons to
choose OFF.
3 Press the 6
sound volume of each of the
speakers
Adjust the sound volumes so that you can
listen to the sounds at the same volume
when you are sitting where you would
normally sit to watch the TV.
LEFT/RIGHT:
The left or right of the front speakers
CENTRE:
The centre speaker
LS/RS:
The left or right of the surround speakers
If REAR SPEAKER is set to OFF, LS and
RS are not displayed.
SUBWOOFER:
TV woofer or external subwoofer
• A test signal is not output from the
subwoofer in the TEST MODE. After
using the TEST MODE to adjust the
balance of the other speakers, stop the
test signal and adjust the volume of the
subwoofer while playing back some
actual sounds.
4 Press the a
the settings
The menu disappears.
5
5
5
When using the front speaker system or
subwoofer system with the TV, it is
recommend that this TEST MODE is used
to adjust the speaker volume levels each
time the system is used.
Using the TV's menu
6 buttons to adjust the
6
6
a button to complete
a
a
27