Bridge Function - Amica PBF4VI511FTB4S Serie Gebrauchsanweisung

OPERATION
The Stop'n go function can be activated for a maximum of 10 minutes. If the
Stop'n go function is not deactivated within this time, the appliance or will
switch itself off.
If the appliance was accidentally switched
off using the on/off sensor (1), the Stop'n go
function makes it possible to quickly restore
the settings. To restore the settings after the
appliance has been switched off using the
on/off sensor (1), touch the on/off sensor (1)
again within 6 seconds. „0" will be shown on
all cooking zone displays (3) and the LED
pilot light will start flashing above the Stop'n
go function sensor field (7). Then, during the
next 6 seconds, touch the Stop'n go function
sensor field (7). Cooking zone displays (3)
will show the heat setting that was previously
set before the appliance was accidentally
switched off.
Funkcja Bridge
The Bridge function allows pairing of two cooking zones into a single combined cooking
zone. The Bridge function is very convenient, especially when cooking in large pots such as
a baking pan.
To activate the bridge function simultane-
ously touch two left or two right cooking
zone selection sensor fields (3). The rear
cooking zone display will show „ " while
the front cooking zone display will show „0".
The desired heat setting is selected by sli-
ding your finger across the heat selection
sensor field (2).
Now both cooking zones can be
controlled at the same time.
To deactivate the Bridge function, simulta-
neously touch the same two left or two ri-
ght cooking zone selection sensor fields (3),
which were used to activate the Bridge func-
tion. The respective cooking zone displays
will show „0".
Now both cooking zones can be
controlled independently.
Downloaded from www.Manualslib.com manuals search engine
3
1
3
61
3
7
3
2