Timer Settings On Remote Control; Set Current Day And Time; Set On/Off Time And Temperature On A Weekly Cycle; Open Window Warning - Napoleon NEFL42HI-EU Installation Und Betriebsanleitung

operating instructions
EN
6.3

timer settings on remote control

6.3.1 set current day and time

1. Press once. When "MON" (Monday) begins fl ashing, use
2. Press . When the hour digits begin fl ashing, use
3. Press again. When the minute digits begin fl ashing, use
4. Press again. The current time is now set.

6.3.2 set ON/OFF time and temperature on a weekly cycle

1. Press . When "MON" begins fl ashing, press
the desired hour and minute to turn on the heater. Press
"ON" timer.
note:
The timer can only be adjusted in 30-minute increments (i.e. 00:00 - 00:30; 00:30 - 01:00, etc.).
2. Press . When "OFF" begins fl ashing, use
Press at any time to clear the digits and shut down "OFF" timer.
3. Press again. When "18" begins fl ashing, use
note:
If the temperature was previously set, those digits will be shown instead of "18".
4. Press again. When "TUES" appears on the screen and "ON" begins fl ashing, use
desired hour and minute to turn on the heater for Tuesday.
5. Press again. When "OFF" begins fl ashing, press
the heater for Tuesday,
6. Press again. When "18" begins fl ashing, use
7. Repeat steps 1 to 6 to set the "ON/OFF" time and temperature for Wednesday, Thursday, Friday, Saturday,
and Sunday.
8. Press or
the middle of the appliance. The appliance will "beep" once to confi rm that programming has been success-
ful.

6.3.3 open window warning

If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open
window nearby. In order to conserve energy, the heater will automatically switch from High Heat to Low Heat, or if
the heater is already at Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will fl ash "88"
three times before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will fl ash "88" con-
tinuously.
To reset the heating function, see "operating remote control" section.
26
W415-2803 / B / 06.01.20
to complete programming, ensuring to aim the remote control at the receiver, located in
to select the current day.
to select the current hour.
to select the current minute.
3 times. When "ON" begins fl ahing, use
at any time to clear the digits and shut down
to select the desired hour and minute to turn off the heater.
to select the desired temperature for Monday.
to select the desired hour and minute to turn off
to select the desired temperature for Tuesday,
to select
to select the