Troubleshooting; Information On Display Panel - Siemens EQ.500 classic TP507DX4 Gebrauchsanleitung

en Troubleshooting

Troubleshooting

Troubleshooting
You can rectify minor faults on your appliance yourself. Read the troubleshoot-
ing information before contacting after-sales service. This will avoid unneces-
sary costs.
WARNING
Risk of electric shock!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out by trained specialist
▶
staff.
Only use genuine spare parts when repairing the appliance.
▶
If the power cord of this appliance is damaged, it must be replaced by the
▶
manufacturer, the manufacturer's Customer Service or a similarly qualified
person in order to prevent any risk.

Information on display panel

Fault
Display shows "Close" des-
pite the fact that the door is
closed.
Display shows "Please
empty drip tray and rein-
sert." despite the fact that
the drip tray is empty.
Display shows "Please refill
water tank" despite the fact
that the water tank is full.
76
Cause
Door is not properly closed.
Appliance is too hot.
Appliance is switched off
and does not detect empty-
ing.
Drip tray is soiled.
Water tank is wrongly inser-
ted.
Carbonated water is in the
water tank.
Float is stuck in the water
tank.
New water filter was not
rinsed as per instructions.
Air is in the water filter.
troubleshooting
Press the door firmly shut.
▶
Disconnect the appliance from the
1.
mains.
Wait 1 hour so the appliance can
2.
cool down.
Switch the appliance on, and re-
1.
move the drip tray.
Re-insert the drip tray.
2.
Clean the drip tray thoroughly.
▶
Insert the water tank correctly.
▶
Fill the water tank with fresh tap wa-
▶
ter.
Remove the water tank.
1.
Clean the water tank thoroughly.
2.
Rinse the water filter according to
1.
the instructions.
→ "Inserting and activating the wa-
ter filter", Page 63
Place the water filter into operation.
2.
Immerse the water filter in water
1.
with the opening facing upwards
until no more air bubbles escape.