Inhaltsverzeichnis
Werbung
5. Additional safety codes for hot air gun
1 ）
Do not put your hand over the air inlet or block it in any way.
2）
During use, the temperature of the nozzle and other accessories will increase dramatically. Only touch these parts after they
have completely cooled down.
3）
Be sure to turn off the power before putting down the tool.
4）
Do not leave the machine unattended while it is operating.
5）
The accidental use of the hot air gun may cause a fire risk.
6）
Do not use the hot air gun in wet environments or in the presence of flammable or explosive gases.
Only store the hot air gun after it has completely cooled down.
7）
As toxic fumes may be generated during the operation of the hot air gun, ensure proper air circulation.
8）
Do not use the hot air gun as a hair dryer.
9）
Do not block the air inlet or outlet, or else the hot air gun may become overheated and sustain damage.
10）
11 ）
Do not point the hot air gun at anyone.
Do not touch the metal air outlet as it will become very hot during use. It will remain at a high temperature for 30 minutes after
12）
being turned off.
Do not move the hot air gun closer to any object while it is operating or immediately after the work is complete.
13）
Do not drop any object into the nozzle, as this could cause electric shock. As the machine will generate high temperatures while
14）
operating, do not look into it as it starts up.
Do not let paint adhere to the scraper at the air outlet as it could eventually ignite.
6. Paint removal
Do not use this tool to remove paint that contains paint. Flaking paint, residue and fumes may contain toxic lead. The lead accumulated
on the surface may be ingested accidentally along the hand-to-mouth route. Even a small amount of lead can cause irreversible damage
to the brain and nervous system, and children and fetuses are the most vulnerable.
For paint removal, make sure that the workplace is closed and wear a dust mask.
Do not burn paint. Use a scraper and keep the air vent at least 25 cm from the painted surface. If you scrape the paint vertically, you
should scrape it downwards to prevent paint from falling into the hot air gun and igniting.
Clean the site thoroughly after the work is complete, and dispose of removed paint safely.
7. Assembly and commissioning
Assemble and commission the machine only when it is unplugged.
The air temperature may be adjusted to correspond to a wide range of applications. The table below shows the different application
settings:
Setting
Gear I
10
97924
中文
EN
Application
Cool parts with a hot surface.
Cool the air outlet to replace the nozzle.
DE
RU
KO
PT
JA
ES
Werbung
Inhaltsverzeichnis
