(Dvd-F1080 Only); Troubleshooting - Samsung DVD-FP580W Bedienungsanleitung

Troubleshooting

Before requesting service (troubleshooting), please check the following.
Problem
No operations can be
performed with the
remote control.
Disc does not play.
5.1 channel sound is
not being reproduced.
The icon appears
on screen.
Disc Menu doesn't appear.
Play mode differs from the
Setup Menu selection.
The screen ratio
cannot be changed.
No audio.
The screen is blocked
Forgot password
If you experience
other problems.
The picture is noisy or
distorted
No HDMI output.

(DVD-F1080 only)

Abnormal HDMI output
screen. (DVD-F1080
only)
HDMI output Jitter
(DVD-F1080 only)
32
• Check the batteries in the remote control.
They may need replacing.
• Operate the remote control at a distance of no more than 20 feet.
• Remove batteries and hold down one or more buttons for several minutes to drain
the microprocessor inside the remote control to reset it. Reinstall batteries and try
to operate the remote control again.
• Ensure that the disc is installed with the label side facing up.
• Check the region number of the DVD.
• 5. 1 channel sound is reproduced only when the following conditions are met. :
1) The DVD player is connected with the proper Amplifier
2) The disc is recorded with 5.1 channel sound.
• Check whether the disc being played has the "5.1 ch" mark on the outside.
• Check if your audio system is connected and working properly.
• In a SETUP Menu, is the Audio Output set to Bitstream?
• The features or action cannot be completed at this time because:
1. The DVD's software restricts it.
2. The DVD's software doesn't support the feature (e.g., angles).
3. The feature is not available at the moment.
4. You've requested a title or chapter number or search time that is out of range.
• Check if the disc has a Menu.
• Some of the functions selected in the Setup Menu may not work properly if the
disc is not encoded with the corresponding function.
• The Screen Ratio is fixed on your DVDs.
• Make sure you have selected the correct Digital Output in the Audio Options
Menu.
• Press the
button (in front panel) for more than 5 seconds under no disc
inside. All settings will revert to the factory settings.
• Press the button (in front panel) for more than 5 seconds
under no disc inside. All settings including the password will revert to the factory
settings. Don't use this unless absolutely necessary.
• Go to the contents and find the section of the instruction book that contains the
explanations regarding the current problem, and follow the procedure once again.
• If the problem still cannot be solved, please contact your nearest authorized ser-
vice center.
• Make sure that the disc is not dirty or scratched.
• Clean the disc.
• Check the Video output is HDMI enabled.
• Check the connection between the TV and the HDMI jack of DVD player.
• See if the TV supports this 480p/576p/720p/1080i/1080p DVD player.
• If snow noise appears on the screen, it means that TV does not support HDCP
(High-bandwidth Digital Content Protection).
• Check your TV system setup correctly.
• The screen Jitter phenomenon may occur when frame rate is converted from
50Hz to 60Hz for 720P/1080i/1080p HDMI (High Definition Multimedia Interface)
Output.
• Please refer to the user's manual of your TV.
Action
Page
P3
P5
P13-14
P26~27
P25~30
P27~28
P26~27
P15
P29
P2
P12~13
P12~13
P27~28