Technical Data; Installation; Unpacking - Electrolux EWF 167320 W Benutzerinformation

Spinning starts late or the
machine does not spin:
The machine makes an un-
usual noise:
No water is visible in the
drum:
If you are unable to identify or solve the
problem, contact our service centre. Before
telephoning, make a note of the model, se-
rial number and purchase date of your ma-
chine: the Service Centre will require this
information.

TECHNICAL DATA

Dimensions
Electrical connection
Voltage - Overall power - Fuse
Water supply pressure
Maximum Load
Spin Speed

INSTALLATION

UNPACKING

All transit bolts and packing must be re-
moved before using the appliance.
You are advised to keep all transit devices
so that they can be refitted if the machine
ever has to be transported again.
Downloaded from www.Manualslib.com
Problem
The electronic unbalance detection device has cut in because the
laundry is not evenly distributed in the drum. The laundry is redis-
tributed by reverse rotation of the drum. This may happen several
times before the unbalance disappears and normal spinning can
resume. If, after 10 minutes, the laundry is still not evenly distrib-
uted in the drum, the machine will not spin. In this case, redistrib-
ute the load manually and select the spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select
the spinning programme.
The machine is fitted with a type of motor which makes an unusual
noise compared with other traditional motors. This new motor en-
sures a softer start and more even distribution of the laundry in the
drum when spinning, as well as increased stability of the machine.
Machines based on modern technology operate very economically
using very little water without affecting performance.
Width
Height
Depth
Information on the electrical connection is given on the rating
plate, on the inner edge of the appliance door.
Minimum
Maximum
Cotton
Maximum
manuals search engine
Possible cause/Solution
60 cm
85 cm
60 cm
0,05 MPa
0,8 MPa
7 kg
1600 rpm
1. After removing all the packaging, care-
fully lay machine on it's back to remove
the polystyrene base from the bottom.
electrolux 21
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...