Technical Data; Troubleshooting - AEG AR 4023 DVD Bedienungsanleitung, Garantie

The term "Dynamic Range" describes the ratio of quietest
and loudest sound. If the dynamic range is very large, you
will experience very quiet and very loud sounds.
This may cause replay problems. Let us assume that you
are watching a DVD in a relatively loud environment. You
can now increase the volume to be able to hear also the
very quiet passages, however with the disadvantage that
loud passages will be unacceptably loud. In this case it
would make sense to compress the dynamic range (i.e.
reduce) and increase the output volume at the same time.
• FULL -2/8: The dynamic range is compressed slightly
(2/8) to full (FULL).
• OFF: The dynamic range is not compressed at all
(default).
Dual Mono
The Audio output is normally in stereo. Here you have
the possibility to choose Mono-output instead of Stereo-
output.
• Stereo: The Audio output is in Stereo (default).
• Mono L: The Audio output is in Mono. In this case the
signal of the "left" stereo channel is transmitted to all
speakers.
• Mono R: The Audio output is in Mono. In this case the
signal of the "right" stereo channel is transmitted to all
speakers.
• Mix Mono: The Audio output is in Mono. In this case
the signal of the "both" stereo channel is transmitted
to all speakers.

Technical data

General
Supply voltage ................................DC 12 V (negative earthing)
Power consumption ..........................................................15 A max.
Power .......................................................................... 4 x 80 W PMPO
Monitor ........................................................................... 7.6 cm/3" TFT
FM band
Frequency range...................................... 87.5 MHz ~ 108.0 MHz
Effective sensitivity ................................................................ 10 dBµ.
AM band
Frequency range............................................522 kHz ~ 1600 kHz
Effective sensitivity ................................................................36 dBµ.
Downloaded from www.Manualslib.com manuals search engine
(Line-Out)
Signal format .......................................................................PAL/NTSC
Video Output (Composite Video) ....................1.0 V (P-P) 75 Ω
CD/DVD player
System ..................................................................MP3 Audio System
Suitable CDs ................CD/CD-R/CD-RW/MP3/DVD/VCD Disks
Playable bit rates ..................................................... 32 - 320 kBit/s
Housing dimensions ................................ 178 W x 50 H x 203 D
Regionalcode .................2 (=Europe, Greenland, South Africa,
Egypt and Middle East, Japan)
Net weight ..................................................................................1.23 kg
Subject to technical changes without prior notice!
This device has been tested according to all relevant cur-
rent CE guidelines, such as electromagnetic compatibility
and low voltage directives, and has been constructed in
accordance with the latest safety regulations.

Troubleshooting

Before going through the checklist please make all the
connections first. If you still have questions after going
through the checklist, please consult your local customer
service representative.
Fault Symptoms Cause
CDs are drawn The transport
only half way screws have not
into the CD tray. been removed.
After inserting The CD is inserted
a CD the device the wrong way
automatically round.
switches to Ra-
dio mode.
CD cannot be There is no CD
selected using inserted.
the MODE but-
ton.
The CD does not The volume con-
play back after trol is set too low.
being inserted
The device has
into the device.
not been correctly
connected.
CD works The surface of the
intermittently road is uneven.
(dropouts).
The device is not
firmly installed.
ENGLISH
35
(12 cm disks)
Solution
Remove the trans-
port screws.
Insert the CD right
way round.
Insert a CD.
Turn up the volume.
Check the +12 V
and earth connec-
tion.
Wait until the road
becomes smoother
before playing the
CD.
Install the device
firmly. Ensure that
the rear attachment
is used if the vehicle
does not have any
suitable retainer for
the rear section of
the device.