Monthly maintenance
The interval of maintenance depends on the mode of operation, however it should be performed
at least once a month:
Unlock eccentric locks and unfold planer tables
Disassemble the side cover
No
Components
Machine complete
1
Planer table
Thicknessing table
Mortising table
2
Adjusting cylinder of
thicknessing table
3
Power unit
4
Feed and out feed rolls
5
Table bearings
6
Sliding surfaces of
mortising unit
7
Height adjustment of
mortising unit
14.2
V-belt
Remove side cover. Check the tension. The belt should not yield more than 10mm.
If tensioning of the belt is necessary proceed as follows:
Loosen the motor bracket screws. Adjust the v-belt tension by raising / lowering the motor.
Tighten the screws when the tension is correct and reinstall the side cover.
HOLZMANN MASCHINEN GmbH
General cleaning of housing and housing interior
Cleaning of the surface
Apply the surface with lubricant
Cleaning and lubricating of the sliding surface
Lubricating of drive chain and sprockets
Check the tension of the chain tensioner
Check the tension of the v-belt and tighten if it necessary
Cleaning the rolls
Cleaning and lubricating of the table bearings
Cleaning and lubricating of the sliding surface
Cleaning and lubricating of all levers and spindles
www.holzmann-maschinen.at
MAINTENANCE
To do
HOB 305PRO / HOB 305PLL
45