Assembly Preparation / Worktop / Kitchen Furniture; Safety Instructions For The Kitchen Furniture Fitter - GUTMANN VIENTO Montageanleitung

PREPARATIONS

Assembly preparation / Worktop / Kitchen furniture :

Safety instructions for the kitchen furniture fitter

• Veneers, adhesives or plastic coverings of adjacent furniture must be temperature-
resistant (min. 75°C). If the veneers and coverings are not sufficiently temperature-
resistant, they may deform.
• The use of solid wood wall end strips on the worktop behind the hob is permitted, provi-
ded that the minimum distances are observed in accordance with the installation sket-
ches.
• The minimum distances of the recess cut-outs to the rear according to the installation
sketch must be observed.
• For installation directly next to a tall cabinet, a safety distance of at least 800 mm must
be maintained. The side surface of the tall cabinet must be covered with heat-resistant
material.
• The packaging materials (plastic foils, polystyrene, nails, etc.) must be taken out of the
reach of children, as these parts represent possible sources of danger. Small parts could
be swallowed and foils pose a suffocation hazard.
• Additional underbody protection is not necessary with the Viento.
Ventilation
• The induction hob has a fan that automatically switches on and off. If the temperature va-
lues of the electronics exceed a certain threshold, the fan starts at a low speed. If the in-
duction hob is used intensively, the fan switches to a higher speed. If the electronics ha-
ve cooled down sufficiently, the fan reduces its speed and switches off again automati-
cally.
The distance between the induction hob and kitchen furniture or built-in appliances must
•
be chosen so that sufficient ventilation of the induction is guaranteed.
To ventilate the hob electronics,
•
open the rear wall of the base
cabinet in the area of the hob.
The front crossbar of the base
cabinet must be removed over
the entire width of the hob.
In addition, an air gap of at
•
least 5 mm at the front below
the worktop is mandatory.
Underside may not be blocked !
EN
21