JUICE BOOSTER 2 Bedienungsanleitung Seite 29

Power
Rated current
Mains voltage
Residual current device
Protection class
IP protection rating
Vehicle-end connector
Mains-end plug
Total cable length
Temperature range
Operating elevation limit
Impact and drop-proof
Colour
Material
Standards
Fault indications (FAULT)
⚠ D A N G E R
In case of faults, all of the LEDs will flash red,
Function display
User Manual JUICE BOOSTER 2 [JTJB2-EU2R*] V 3.1
1. 4 kW - 22 kW AC
6 A to 32 A
230 V (single-phase) / 400 V (3-phase)
RCD DC 6mA, AC/DC 30mA with protective conductor monitoring
I
IP67 (protects against damaging quantities of dust and immersion
in water for short periods)
Type 2 (EN 62196) / Type 1 (SAE J1772), cable length 3. 1 m
Over 25 self-detecting adapters are available for domestic, industri-
al and EV sockets, 1. 4 m power cable + approx. 30 cm adapter
approx. 5 m
Storage: -30°C to +60°C
Operation: -30°C to +50°C
Up to 3,000 m above sea level
Able to withstand a wheel load of 2,000 kg should you drive over
it by mistake (the rubber casing may burst, and the housing and
plug may be scratched or bent, but live components will not be
exposed).
Drop-proof from heights up to 100 cm
Metallic anthracite, black rubber caps and cables
Anodised aluminium with rubber caps
IEC 62752, IEC 62196, 61851-Mode2, 61851-Mode3 (with Type-2
and Type-3c adapters), EMC, RoHS
The LED(s) Possible cause
Red LED Initialisation
showing error
at BOOST-
ER
alternating with a single red LED indicating the
fault detected. You can reset the JUICE BOOSTER
2 by unplugging the mains-end connector and
then plugging it back in. Further actions for fault
isolation can be found at www. juice-world.com/
service > JUICE BOOSTER
Action
Disconnect the JUICE BOOSTER
2 from the vehicle and the mains.
Restart the process. Charge your
vehicle at other power outlets and
locations. If the same error recurs:
Stop using the device and contact
JUICE Customer Service.
29