JUICE BOOSTER 2 Bedienungsanleitung Seite 25

• Reducing the charge intensity is always rec-
ommended for old installations and continuous
operation. This may also be necessary if mul-
tiple e-cars are being charged at outlets that
share fuses, or where the outlets are fused for
and specifically state lower amperage values.
• For safety reasons, the charge intensity cannot
be increased beyond the charge intensity de-
termined by the JUICE BOOSTER 2.
• The selected setting will be saved automatical-
ly after approx. 5 seconds.
The LED then displays the selected
ampere value in solid green.
The JUICE BOOSTER 2 saves the last charge
intensity setting used with a particular mains
adapter, and that setting is restored after any
power interruption or when the device is plugged
in again with the same adapter.
Changing the operating mode
(MODE)
• Press and hold down the SELECT button for
approx. 5 seconds (before plugging the vehi-
cle-end connector into the vehicle charging
socket, or within 30 seconds after plugging it in).
All LEDs will briefly flash yellow,
after which the currently set oper-
ating mode will flash yellow in rapid
sequence, thereby signalling that it's
ready to change the operating mode.
• Set the desired operating mode by pressing
the SELECT button repeatedly until the desired
mode is reached.
The selected setting will be saved
automatically after approx. 5 seconds.
The selected operating mode is then
displayed in slowly flashing yellow.
STANDARD mode
For operation in all countries except the UK,
France and Norway.
UK/FR mode
This mode must be selected for charging in
the United Kingdom and France (as it limits the
Schuko plug to 10 A or 8 A / 14 A for GreenUp).
NORWAY mode
This mode, and only this mode, must be selected
for charging in Norway (configures the device for
User Manual JUICE BOOSTER 2 [JTJB2-EU2R*] V 3.1
use in earth-free IT networks).
⚠ D A N G E R
EARTH OFF mode
Disables the device's internal earth conductor
check. This mode may only be used once you
have checked to verify that the electrical installa-
tion and earthing have been correctly connected.
Unbalanced loads and other inadequacies in the
grid can result in the earth conductor check de-
tecting an irregularity with the earthing despite it
being correctly connected. For technical reasons,
this circumstance cannot be resolved in any other
way. This situation has been repeatedly observed
in Italy, among other places.
For your safety, reset the operating mode to
STANDARD once you are charging from a differ-
ent socket.
Charging your vehicle at public
charging stations
1. Select the fitting adapter (Type 2 or Type 3).
2. Connect the JUICE CONNECTOR of the JUICE
BOOSTER 2 to the JUICE CONNECTOR of the
adapter, as described above.
3. Plug the connected adapter into the charging
station.
4. Couple the vehicle-end connector of the JUICE
BOOSTER 2 to the vehicle's charging socket.
5. Release the charging process at the charging
station, or pay, as needed.
6. The charging process begins automatically.
The sequential flashing orange LEDs
indicate that charging is in progress.
Stopping the charging process
1. Stop the charging process at the controls inside
the vehicle.
2. This releases the lock on vehicle's charging
coupling. If you are charging the vehicle at a
charging station, the lock at the charging station
is likewise released.
3. First disconnect the connector coupled to the
25