Switching On/Off - Silvercrest SHZK 600 A1 Bedienungs- Und Sicherheitshinweise

˜ Switching on/off
Connect the power plug
outlet .
Switching on/off: Press the on/off switch
once .
3 ] [
Disconnect the power plug
socket-outlet if you do not use the product .
˜ Emptying the dust container
NOTES:
Empty the dust container
possible, since emptying can lead to a cloud
of dust .
Empty the dust container before the filling
line marked with MAX is reached .
Press the release button
container from the motor unit
[ 7 ]
Hold the dust container
Press the lock on the side of the dust
[ 8 ]
container down to open the bottom and
[ 7 ]
thus discharge the dust (Fig . F) .
Close the bottom . The lock
lock in place (Fig . G) .
Insert the dust container
unit . The release button
6 ] [
lock in place (Fig . H) .
˜ Cleaning and care
m
DANGER! Risk of electric shock!
Disconnect the power plug
socket-outlet before cleaning the product .
Never touch the power plug with moist or
wet hands .
Always keep the power plug and power
cord dry .
to a socket-
5 ] [
from the
[ 5 ]
outdoors if
7 ] [
and lift the dust
[ 2 ]
(Fig . E) .
6 ] [
over a waste bin .
7 ] [
must audibly
[ 8 ]
into the motor
[ 7 ]
must audibly
[ 2 ]
from the
5 ] [
m
WARNING! Risk of electric shock!
Never immerse the electric parts of the
product in water or other liquids . Never hold
the product under running water .
Switch off the product and disconnect the
power plug from the socket-outlet .
[ 5 ]
Do not use any corrosive or abrasive
cleaning agents .
Remove coarse dirt by hand .
Clean the product with a damp cloth . For
stubborn dirt, use a damp cloth and a mild
detergent and clean the product again .
Dust container and filter
NOTE: Check the HEPA filter
for damage and deformation . A damaged or
deformed HEPA filter cannot be cleaned and
must be replaced . This is necessary in order
to maintain the functionality of the product
and to protect the product from damage .
Replacement HEPA filters
IAN 343957_2001) can be reordered .
Order online
www.optimex-shop.com
Remove the dust container
(see "Emptying the dust container") .
Remove the dust container lid
the clip for opening the dust container lid
which is located at the side, upwards (Fig . I) .
Turn the HEPA filter
that points to
(Fig . J) .
Remove the filter case
from the dust container
regularly
[ 22 ]
(article number
22 ] [
7 ] [
by pressing
1 ] [
[ 23 ]
counter-clockwise so
22 ] [
on the filter case
21 ] [
with HEPA filter
[ 21 ] 22 ] [
(Fig . K) .
7 ] [
GB/IE
,
25