Switching On / Off; Fastening The Storage Bag To A Surface In Your Car Boot; Servicing And Cleaning; Disposal - Silvercrest SHS 12.0 A1 Bedienungs- Und Sicherheitshinweise

Operation / Servicing and cleaning / Disposal
I nsert the small brush
nozzle .
4
Crevice tool :
8
Use this attachment to get into narrow, difficult-to-
access places.
I nsert the crevice tool
nozzle .
4
Removing attachments:
S imply pull the attachment off the front nozzle
or the extension hose

Switching On / Off

Q
I nsert the 12 V plug
cigarette lighter socket of the vehicle, see Fig. C.
T o switch the device on, press the ON / OFF
switch forwards into the ON position.
2
T o switch the device off, press the ON / OFF
switch back into the OFF position.
2
P ull the 12 V plug
3
after use.
Tip: If you going to vacuum for a long period, we
recommend that you carry out the cleaning with
the engine running.
fastening the storage bag to a
Q
surface in your car boot
Y ou can fasten the storage bag
place, e.g. in the boot of your car. To do this,
press the bag lightly against a suitable textile
surface in your vehicle, for example the back
of the rear seats. The storage bag
place by two hook and loop fastening strips.

Servicing and cleaning

Q
The device requires no maintenance.
A TTenTIOn! Before you clean the device
itself, pull the 12 V plug
socket, otherwise there Is a risk of electric shock.
8 GB/CY
snugly into the front
7
snugly into the front
8
.
5
into the 12 V socket /
3
out of the 12 V socket
in a suitable
9
is held in
9
out of the 12 V
3
C lean all the housing with a soft, dry cloth.
Never use liquids or cleaning agents, as they
may damage the device.
F or the best possible performance, you should
empty the dust container
use and when the suction power drops.
P ress the unlocking button
dust container
T ake out the dust filter
clean the dust filter better if you detach it from the
end seal. To do this, hold the end seal firmly
4
and twist the filter off carefully anticlockwise
(bayonet fitting). Rinse out the dust filter
thoroughly in cold water and allow both parts
(filter and end seal) to dry completely. Attach
the filter back on to the end seal.
E mpty the dust container
C arefully replace the dust filter
the dust container
cleaner without the dust filter
A ttach the dust container
on to the housing
engage.
ATTenTIOn! The front nozzle
and unobstructed at all times. Blockages can lead
to overheating and damage to the motor.

Disposal

Q
The packaging is composed of environ-
mentally-friendly materials that can be
disposed of at a local recycling centre.
Do not dispose of electrical
devices with the household
rubbish!
In accordance with European Directive 2002 / 96 / EC,
worn out electrical devices must be collected
separately and taken for environmentally compatible
recycling.
Contact your local refuse disposal authority for
more details of how to dispose of your worn out
electrical devices.
immediately after
10
and take the
1
out of the housing
10 12
. You will be able to
11
completely.
10
back into
11
. Never use the vacuum
10
in place.
11
carefully back
10
and ensure the two parts
12
must be free
4
.
11