Putting Into Operation - Jackle JESS WELDING maxiMIG 250 Betriebsanleitung

maxiMIG 250/300

6 Putting into operation

Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly
and repair work:
• Switch off the power source.
• Close off the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
Risk of injury
Increased noise pollution.
• Wear personal protective equipment: Ear protectors
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
Risk of injury
Feet may be crushed due to sudden rolling movement of the power source.
• Inspect the safety of the machine.
• Position on flat, even surfaces only.
Risk of injury
Heavy weight.
• Ensure that you slow down in good time when moving the device.
NOTICE
• Please take note of the following instructions:
• Only qualified personnel are permitted to perform work on the device or system.
• Components must only be used in environments with sufficient ventilation.
BA-0005 • 2020-10-19
DANGER
CAUTION
WARNING
WARNING
CAUTION
 Product description on page EN-3
6 Putting into operation
EN - 7