ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Type of handle
No load speed
Overall length
(without cutting tool)
Nylon cord diameter
Applicable cutting tool and
cutting diameter
Rated voltage
Net weight
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
•
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Recommended battery adapter
Battery adapter
•
The battery adapter(s) listed above may not be available depending on your region of residence.
•
Before using the battery adapter, read instruction and cautionary markings on the battery adapter.
Noise
Nylon cutting head
•
Even if the sound pressure level listed above is 80 dB (A) or less, the level under working may exceed 80 dB
(A). Wear ear protection.
NOTE: The declared noise emission value(s) has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be used in a preliminary assessment of exposure.
Nylon cutting head
(P/N: 198893-8 / 191D89-4)
Cutting tool
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
Sound pressure level (L
pA
dB(A)
L
dB(A)
Uncer-
pA
tainty (K)
dB(A)
74.8
0.4
9 ENGLISH
DUR192L
Loop handle
-1
2: 0 - 6,000 min
-1
1: 0 - 4,500 min
1,670 mm
2.0 mm
300 mm
D.C. 18 V
2.7 - 3.0 kg
DC18SH
PDC01
)
Sound power level (L
)
WA
dB(A)
L
dB(A)
Uncer-
WA
tainty (K)
dB(A)
87.8
1.9
Applicable
standard
ISO22868
(ISO11806-1)/
EN50636-2-91