Pneumatic Connection; Connecting The Control Medium - bürkert 2060 Schnellstart

Type 2060, 2061
→ Counter with a suitable open-end wrench on the wrench flat
of the nipple.
→ Place a suitable open-end wrench on the hexagon head of the
actuator.
→ Set the actuator to the required position.
7.7

Pneumatic connection

WARNING!
Risk of injury due to connecting unsuitable hoses.
▶ Only use hoses that can withstand the pressure and tempera-
ture of the medium.
▶ Note the technical data provided by the hose manufacturer.
For control function I: Risk of pilot pressure failure.
The valve stays in an undefined position in the event of a pilot
pressure failure.
▶ To ensure a controlled restart of the device, apply pilot pressure
and activate the medium.

7.7.1 Connecting the control medium

If the position of the pilot air ports is unfavourable for
installing the hoses, these can be seamlessly aligned by
rotating the actuator by 360°.
The procedure is described in chapter "7.6".
Control function A:
→ Connect control medium to pilot air port 1.
Installation
Control function B:
→ Connect control medium to pilot air port 2.
Control function I:
→ Connect control medium to pilot air port 1 and 2
Pressure on pilot air port 1 opens the valve.
Pressure on pilot air port 2 closes the valve.
Pilot air port CFB, CFI
Exhaust port CFA
Pilot air port CFA, CFI
Exhaust port CFB
Fig. 7: Ports
Silencer
1)
→ Screw the silencer into the exposed exhaust port.
For usage in an aggressive environment, we recommend
using a pneumatic hose to drain all free pneumatic ports
in a neutral atmosphere.
Pilot air hose
Pilot air hoses of sizes 6/4 mm or ¼" can be used
1) Silencers for reducing the loudness of the exhaust air can be ordered
as an accessory.
2) Push-lock fittings can be ordered as accessories.
English
2
1
.
2)
13