Inhaltsverzeichnis; Introduction - McCulloch CS 35 Bedienungsanweisung

Introduction..................................................................... 8
Safety..............................................................................9
Assembly...................................................................... 12
Operation...................................................................... 13
Maintenance................................................................. 19
Product description
The McCulloch CS 35, CS 35S are chainsaw models
with a combustion engine.
Work is constantly in progress to increase your safety
and efficiency during operation. Speak to your servicing
dealer for more information.
Product overview
(Fig. 1)
1. Cylinder cover
2. Air purge bulb
3. Start/stop switch
4. Choke control
5. Rear handle
6. Information and warning decal
7. Fuel tank
8. Idle speed screw (T)
9. Starter rope handle
10. Starter housing
11. Chain oil tank
12. Rating plate
13. Chain tensioning screw
14. Clutch cover
15. Throttle trigger lockout
16. Front handle
17. Front hand guard
18. Muffler
19. Guide bar
20. Bar tip sprocket
21. Saw chain
22. Spiked bumper
23. Chain catcher
24. Throttle trigger
25. Guide bar cover
26. Operator's manual
27. Combination wrench
8
Contents
Troubleshooting............................................................ 24
Transportation and storage...........................................25
Technical data.............................................................. 26
Accessories.................................................................. 27
EC Declaration of Conformity....................................... 28

Introduction

Intended use
This product is intended for sawing in wood.
Note: National regulations can set limit to the operation
of the product.
Symbols on the product
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
(Fig. 9)
(Fig. 10)
(Fig. 11)
Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
This product complies with applicable EC
Directives.
Noise emissions to the environment
according to European Directive 2000/14/EC
and New South Wales legislation "Protection
of the Environment Operations (Noise
Control) Regulation 2017". Noise emission
data can be found on the machine label and
Technical data on page 26 .
in the
Use 2 hands to operate the product.
Do not operate the product with one hand
only.
Do not let the guide bar tip touch an object.
Warning! Kickback can occur when the
guide bar tip touches an object. A kickback
causes a lightning fast reverse reaction that
throws the guide bar up and in the direction
of the operator. Can cause serious injury.
Use the stop switch to stop the engine.
1216 - 002 - 01.09.2020