Air Filter; Fuel Filter - Fuxtec FX-MS152T Original Bedienungsanleitung

Original Bedienungsanleitung FUXTEC FX-MS152T_de_en_fr_rev03
REFILLING TRIMMING LINE
1. For replacement line, use a diameter of
2.4mm (.095in). The spool is capable for a line
up to 6m (20ft) on the 10cm (4") head. Avoid
using a larger line as it may cut down the
trimming performance.
2. Pinch the slotted area on the both sides of
the spool housing to unhook the bottom cap.
3. Take out the spool and pull off the old line.
Put one end of new line through the spool
holes and pull it until the length is equal
between each part of the line.
4. Wind up the line in the correct direction as
indicated on the spool.
5. Hook each end of the line in the slot on the
edge of the spool, and then put the ends
through the eyelets on the housing. Make sure
that the spring and the washers are in place.
6. While holding the spool against the housing,
pull the line ends to release them from the
slot.
7. Line up the slot on the bottom cap with the
hook on the housing, press the cap against the housing until it clicks.

AIR FILTER

The air filter, if clogged, will reduce the engine
performance. Monthly check and clean the
filter element in warm, soapy water as
required. Dry completely before installing. If
the element is broken or shrunk, replace with
a new one.

FUEL FILTER

• When the engine runs short of fuel supply, check the
fuel cap and the fuel filter for blockage.
(1) Fuel filter
46