Stopping Engine; Trimming Grass And Weeds - Fuxtec FX-MS152T Original Bedienungsanleitung

8. Allow the engine to warm up for several minutes before starting operation.
NOTE
1. When restarting the engine immediately after stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due to excess fuel. When the engine
failed to start after several attempts, open the choke and repeat pulling the rope, or
remove the spark plug and dry it.

STOPPING ENGINE

1. Release the throttle lever and run the engine for a half minute.
2. Shift the ignition switch to the STOP position. (OP3)
NOTE
• Except for an emergency, avoid stopping the engine while pulling the throttle lever.
TRIMMER HEAD USAGE
WARNING
1. Always wear eye protection such as safety goggles. Never lean over the
rotating cutting head. Rocks or other debris could be thrown into eyes and face
and cause serious personal injury.
2. Keep the protection guard attached in place at all times when the unit is
operated.

TRIMMING GRASS AND WEEDS

• Always remember that the TIP of the line does cutting. You will achieve better
results by not crowding the line into the cutting area. Allow the unit to trim at its own
pace.
1. Hold the unit so the head is off the ground and is tilted
about 20 degrees toward the sweep direction.
2. You can avoid thrown debris by sweeping from your
right to the left.
3. Use a slow, deliberate action to cut heavy growth. The
rate of cutting motion will depend on the material being
cut. Heavy growth will require slower action than will light
growth.
4. Never swing the unit so hard as you are in danger of
losing your balance or control of the unit.
5. Try to control the cutting motion with the hip rather than placing the full workload on
the arm and hands.
6. Take precautions to avoid wire, grass and dead, dry, long-stem weeds from wrapping
around the head shaft. Such materials can stall the head and cause the clutch to slip,
Original Bedienungsanleitung FUXTEC FX-MS152T_de_en_fr_rev03
42