Fitting/Removing Brush Heads; Operation - Nevadent NAZ 2.4 C3 Bedienungsanleitung

Fitting/removing brush heads

■ To remove the brush head
■ When fitting the brush head
slides precisely into the socket on the brush head
Push the brush head
NOTE
You can order replacement brush heads from our Service department (see
section "Ordering replacement parts").
You can also use the brush heads for the models NAZ 3.7 A1 and
DAZD 3.7 LI B2 (also available from Lidl).
The toothbrush is also compatible with brush heads from the following
©
Oral B
Oral-B Ortho, Oral-B Precision Clean, Oral-B 3D White, Oral-B Cross Action,
Oral-B Stages Power, Oral-B Sensitive, Oral-B Deep Cleaning.
*Oral-B is a registered trademark of Procter & Gamble.

Operation

This toothbrush has 3 different power levels:
–
"Clean": normal speed, orange "Clean" LED
For cleaning the teeth.
–
"Sensitive": slow speed, green "Sensitive" LED
For cleaning the teeth if you have sensitive gums.
–
"Massage": slow speed with short breaks, yellow "Massage" LED
For massaging the gums.
■ Press the On/Off switch
LED
■ Press once more to switch to "Sensitive" mode. The "Sensitive" LED
■ Press a third time to switch to "Massage" mode. The "Massage" LED
lights up.
■ To switch the toothbrush off, press the On/Off switch
NAZ 2.4 C3
down until it completely covers the drive shaft
* models:
lights up.
, pull it upwards and off the drive shaft
, ensure that the drive shaft
once to activate the "Clean" mode. The "Clean"
.
on the handset
.
.
lights up.
once more.
GB │ MT │
49 ■