Foppapedretti Talent Montageanweisungen Seite 26

• ENGLISH •
ASSEMBLY - USE
FASTENING THE SEAT (for use as a pushchair)
Disassembling the seat (fig. 21): press the buttons "a" on both sides and remove the seat by lifting it up.
Fitting the seat: to fit the seat, place it in the position shown in the figure 22. Line up and insert the plastic connectors
of the seat in the slots provided on the pushchair chassis. Press until a click is heard indicating that it has been fastened
correctly.
WARNING: Before use, always check that both the seat supports are fastened correctly to the chassis.
When the seat is lifted upwards, it must not detach from the chassis.
Removing the seat (fig.21): press button "a" on both sides and remove the seat by lifting it.
REVERSIBLE SEAT (fig. 23)
Remove the seat by lifting it, see the paragraph "INSTALL THE SEAT".
Position the seat so that it is forward facing or parent-facing.
Replace the seat on the chassis of the pushchair, see the paragraph "fitting the seat" for correct assembly.
USE
HOW TO OPEN THE PUSHCHAIR (fig. 24, 25, 26, 27)
Move the closing lever "a", as shown in the figure (fig. 24).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened (fig. 25).
Lift up the seat until you hear a CLICK (fig. 26).
Lift up the lever "b" and at the same time push the backrest upwards until you hear a CLICK, this will indicate that it is in
place correctly. Lift up the protective armrest. A click will indicate that it is locked (fig. 27).
WARNING: Before use, pull the seat upwards to check that it has been fastened correctly to the chassis.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked (fig. 35).
TO REGULATE THE BACKREST (fig. 28)
Lift the regulating lever "a" located behind the backrest and recline the backrest to the required position. Release the lever
and make sure the backrest is secured in position.
WARNING (fig. 29): For babies under 6 months of age, the backrest must only be in the fully reclined, horizontal position
at all times.
PARKING BRAKE (fig. 30)
To apply the brake: Press the brake lever, push the pushchair forward gently to ensure the brake has been applied correctly.
To release the brake: lift the lever.
FOOTREST ADJUSTMENT (fig. 31)
Press the lever "A", under the footrest, and adjust the footrest to the chosen position.
ADJUSTING THE HOOD (fig. 32)
The hood can be adjusted to 3 different heights.
Press the button "a" on the back of the hood (fig. 33), on both sides, and raise or lower the hood to position it at the
desired height.
Make sure that the hood is locked in the new position at both sides.
Unfold the hood according to your needs, to protect the child from sunlight.
NOTE: babies' skin is very delicate. NEVER leave baby under direct sunlight. Always make sure that the hood has been
adjusted correctly.
26