Fitting The Hood - Foppapedretti Talent Montageanweisungen

• ENGLISH •
ASSEMBLY
UNFOLD THE STROLLER
CAUTION: make sure that the child, and any other children, are at a safe distance away when carrying out this step.
The moving parts of the stroller must not for any reason come into contact with the child's body.
Move the closing lever "a", as shown in the figure (fig.1).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened.
Lift up the seat until you hear a CLICK (fig. 2).
Lift up the lever "b" and at the same time push the backrest upwards until you hear a CLICK, this will indicate that it is in
place correctly.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked
INSTALL FRONT WHEELS (fig. 3)
Fitting the front wheels (fig. 4): Insert the end bushing into the slot situated in the center of the wheel block.
A click will indicate that it is inserted correctly.
Check that both the wheels have been fastened correctly, if they are pulled downwards they should not be released.
Move lever "a" downward to block the swivel movement, and upward to activate the swivel movement (fig. 4).
Removing the front wheels (fig.5): Press the steel button "b" front wheel released.
REAR WHEELS (fig. 6)
Insert the wheel pin in the hole, a click will indicate it has been fastened in place. Make sure that the wheel has been
secured correctly, it should not come away when it is pulled outwards.
Removing the rear wheels (fig. 7): Press the metal lever "a" on the wheel hub and, at the same time, remove the wheel.
FITTING THE BUMPER BAR
Fitting the bumper bar (fig. 8, 9): Lift up the two attachment points for the handlebar, a CLICK will indicate that they are
locked. Line the bumper bar up with the slots and press on both sides. A click indicates that it has been fastened correctly.
Removing the bumper bar (fig. 10): press button "a" on both sides of the bumper bar and at the same time pull to remove it.
Opening the bumper bar on just one side (fig. 11): press button "a" on one side of the bumper bar and pull to open it
like a gate.
FITTING THE FOOTMUFF
(fig. 12)
Insert the lower part of the footmuff on the seat of the chassis.
Fold the upper part of the footmuff around the bumper bar.
Secure the footmuff to the chassis of the pushchair using the press fasteners. Attach the press studs on both sides.
FITTING THE PUSHCHAIR RAINCOVER (fig. 13)
Fit the raincover over the hood.
Fasten the edges at the back of the raincover using the Velcro tabs.
Fasten the front of the raincover to the chassis of the pushchair using the press studs.
STORAGE BASKET
Disassembly: unhook the 2 rear press studs as shown in fig. 14.
Open the zips from both sides as shown in fig. 15.
Remove the front straps from the buckles as shown in fig. 16, then repeat this process for the straps on the back as shown
in fig. 17.
Assembly: repeat this process in reverse order.

FITTING THE HOOD

Fitting the hood (fig. 18): fasten the hood support to both sides of the chassis.
Fasten the press fasteners of the hood behind the backrest.
Removing the hood (fig. 19, 20): pull and release the hood support from both sides of the chassis.
25