On/Off Trigger Switch - Evolution R165CCSL Originalbetriebsanleitung

WARNING: These pre-use safety checks should
be carried out with the machine disconnected
from the mains power supply.
• Check that all safety guards are operating
correctly, and that all adjustment handles/
screws are securely tightened.
• Check that the blade is secure and installed
correctly. Also check that it is the correct
blade for the material being cut.
• Check the integrity of the power cord.
• Whenever possible clamp the workpiece to a
rigid support structure such as a workbench,
saw horse or similar.
• The operator should always be aware of the
position and routing of the power cable.
PPE
(15)
• The operator should wear all relevant PPE
(Personal Protection Equipment) necessary
for the task ahead.
This could include safety glasses,,full face
mask, dust masks, safety shoes etc.
Note: All CCS series machines are equipped
with a cutting line debris blower. This directs
air from a motor driven fan towards the area to
the front of the blade, thus keeping the cutting
line relatively debris free. This feature will aid the
operator sight and follow the progress of the
saw blade along the cut, keeping any marking-
out lines visible.
WARNING: Any and all dust created is
potentially prejudicial to health.
Some materials can be particularly harmful, and the
operator should always wear a dust mask which is
suitable for the material being worked with.
Professional help and advice should be sought if
the operator is at all unsure about the potential
toxicity of the material to be cut.
WARNING: These machines must never be
used to cut Asbestos or any material that
contains, or is suspected to contain, Asbestos.
Consult/inform the relevant authorities,
and seek additional guidance if Asbestos
contamination is suspected.

ON/OFF TRIGGER SWITCH

(16)
Note: All machines destined for the European
and Australian market are equipped with a
'safety start' trigger switch to enhance operator
safety. (Fig.15)
www.evolutionpowertools.com
To start the motor:
• Push in the safety lock button on the side of
the handle with your thumb.
• Depress the trigger switch.
To stop the motor:
• Release the trigger switch.
WARNING: The motor should never be started
with the saw blade in direct contact with any
surface of the workpiece.
Note: Machines destined for the North
American market are fitted with an ON/OFF
Trigger switch which does not incorporate a
'safety start' trigger switch.
WARNING: If the saw is 'live' (LED Light 'ON'),
avoid unintentionally starting the motor when
picking up the machine from a workbench or
similar. Accidentally depressing the ON/OFF
Trigger switch (positioned in the main handle)
when picking up the machine from rest will
cause the motor to start.
CUTTING TRACKS
Evolution CCSX series machines (refer
to the Specification Page for applicable
models) have been engineered and
featured in such a way as to make them
Cutting Track compatible.
Note: Any circular saw that is capable of being
used with a Cutting Track will have a channel
along the under surface of the sole plate
Evolution machines so equipped can be
attached to, and used with most Cutting Tracks
(Guides) currently available.
Note: Consult the documentation supplied
with the track by the track manufacturer. The
supplied documentation will normally give
the assembly instructions for the track, as well
as information regarding the safe working
practices that need to be employed when
using such equipment.
Cutting Tracks can be employed where:
• The use of a chop or circular saw could
present Health and Safety (H&S) or other
practical workplace issues. For example
when working on a construction site
where very close and accurate control may
be necessary, (working on a roof or on a
scaffolding platform, etc.) using a cutting
24
(Fig. 16)