Disassembly; Disposal; Materials; Consumables - Abicor Binzel ROBO VTS Betriebsanleitung

9 Disassembly

9 Disassembly
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany see TRBS 1203)..

10 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. Observe the regulations on the disposal of electronic scrap and dispose of it at your local waste
disposal site (e.g. recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take note of the following
information:
 9 Disassembly on page EN-12

10.1 Materials

This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.

10.2 Consumables

Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
materials must be stored, transported and disposed of in suitable containers. Please observe the relevant
local regulations and disposal instructions in the safety data sheets specified by the consumables'
manufacturer. Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with
the information provided by the consumables' manufacturer.

10.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
EN - 12
Alignment jig
BAL.0022 • 2017-02-15