Disassembly; Disposal; Materials; Consumables - Abicor Binzel eBOX MFS-V3 Betriebsanleitung

11 Disassembly

11 Disassembly
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Close the gas supply.
• Switch off the entire welding system.
• Disconnect the mains plug.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Observe also the operating instructions of the welding components, such as the MFS-V3 and welding
• Observe the information provided in the following section:
1 Disconnect the cable assembly from the wire feeder.
2 Disconnect the connection leads from the eBOX.

12 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. To correctly dispose of the product, it must first be disassembled.
To correctly dispose of the product, it must first be disassembled. Please take note of the following
information:
 11 Disassembly on page EN-22

12.1 Materials

This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labelled in preparation for their sorting and
separation for later recycling.

12.2 Consumables

Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Please observe the relevant
local regulations and disposal instructions in the safety data sheets specified by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with
the information provided by the consumables' manufacturer.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.

13 Options

13.1 Manual terminal for the MF control

Please see the information in operating instructions BAL.0389.0.
EN - 22
DANGER
torch system, re-circulating cooling unit etc.
 8 Putting out of operation on page EN-19.
eBOX