Installing Or Removing A Blade - Evolution FURY6 Serie Betriebsanleitung

Fig. 26
Fig. 27
Riving Knife
The Riving Knife is a very important component and comes
factory fitted and correctly aligned and adjusted. The Riving
Knife prevents the work from binding as it passes through the
blade. Inspect the Riving Knife at regular intervals and replace it
if it is worn or damaged.
The Riving Knife should be adjusted so that the gap between
the tips of the blade teeth and the edge of the Riving Knife is
approximately 3-5mm. (Fig.26)
To adjust the Riving Knife loosen the two (2) fixing screws
(Fig. 27) slightly using an allen key. When correct alignment is
achieved tighten the fixing screws.
Note: Use only a genuine Evolution Riving Knife, as this is a
dedicated component for this machine. Non genuine parts could
be dangerous. If in any doubt, please contact the Helpline.
Push Stick
A plastic push stick is provided with the machine. When not in
use store the push stick on the machine.
Note: If the push stick becomes damaged it should be replaced.
If the operator makes their own push stick, we recommend that
it follows the same pattern as that supplied. Replacement push
sticks are available from Evolution Power Tools.

INSTALLING or REMOVING a BLADE

WARNING: Only use genuine Evolution blades which are
designed for use in this machine. Ensure that the maximum
speed of the blade is compatible with the machine. Only
perform this operation with the machine disconnected from
the mains supply.
Note: It is recommended that the operator considers wearing
protective gloves when handling the blade during installation
or when changing the machines blade.
Note: The blade is a very precise fit within the Fury6 machine.
Be patient and methodical when changing the blade.
28
www.evolutionpowertools.com