Star TSP800 Serie Bedienungsanleitung Seite 116

(3) DP8340 mode
Switch
1-1 Command emulation
1-2 Command emulation
1-3 Control cord CR
1-4 Character table (See below)
1-5 Character table (See below)
1-6 International character set (See below)
1-7 International character set (See below)
1-8 International character set (See below)
Switch USA & Europe
1-4
1-5
Switch USA
1-6 ON
1-7 ON
1-8 ON
(4) ESC/POS mode
Switch
1-1 Command emulation
1-2 Command emulation
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 Pin #31 (INIT) reset signal
1-6 Handshaking conditions
(conditions for BUSY)
1-7 Automatic status back function
1-8 Should not be changed (Should be set to on)
Switch
2-1~2-4
The factory settings of DIP switch are all on.
I Printer Driver
The printer driver can be downloaded from the following website.
Printer Driver URL : http://www.star-m.jp/eng/dl/dl02.htm
Function
Character Table
ON
ON
International Character Set
France Germany England
OFF ON
ON OFF
ON ON
Function
DIP-SW 2
Function
Always ON
– 113 –
ON
Always ON
Always OFF
Invalid
IBM#1 IBM#2
OFF ON
ON OFF
Denmark Sweden 1
OFF ON
OFF ON
ON OFF
ON
Always OFF
Always OFF
Invalid
Valid
Offline or receive
buffer full
Invalid
ON
Should be set to on
OFF
Same as LF
JAPAN
OFF
OFF
Itary Spain 1
OFF ON OFF
ON OFF OFF
OFF OFF OFF
OFF
Valid
Invalid
Receive buffer full
Valid
OFF