E) Torque Attachment; F) Cutting Attachment - BASETech 2147830 Bedienungsanleitung

e) Torque attachment

Different screws and materials require different torque settings (1-10). The higher the torque, the larger / thicker the
indication on the torque adjustment ring.
1. Adjust the torque adjustment ring
setting. Line it up with the arrow.
2. Always start with a low torque setting and gradually increase until
you reach a satisfactory result. The ability to choose the right set-
ting comes with experience using the tool.

f) Cutting attachment

The cutting attachment (6) contains sharp parts and must
be handled with care during use and replacement. Check
the equipment for damage before use.
The attachment should only be used only for cutting soft
materials (e.g. cardboard or carpet). Incorrect selection of
the cut material can damage the attachment.
Cutting tips
• Set the direction of rotation switch to match the direction indicated
by the arrow (D).
• Insert the material to be cut into the slot (B). The guide rail (E) can
be used when cutting along a surface such as a table.
Cutting should be performed in a slow and smooth motion, let the tool do the work.
• When not in use, lock the trigger in the off position by sliding the rotation direction switch (13) to the middle.
Replacing the cutting disc
1. Remove the attachment from the body.
2. Use a cross head screwdriver to release the fastening bolt (A).
3. A new disc should be inserted over the pin and secured using the fastening bolt.
to the desired
A
B
C
D
E
29