Fagor fd291nf Benutzerhandbuch Seite 26

Reversing the direction the doors open
11. The upper left-hand hinge L is placed inside the
plinth (R6). Remove it and inset it into the housing on
the left on the control panel M . Fasten it with the
two screws (R7).
12. Insert the covers N and fasten them onto the control
panel (R7).
13. So as not to lose the top right-hand hinge, which you
may need later, store it in the housing in the plinth
(R6) .
14. Remove the hole covers O on the left-hand side of
the refrigerator's door (R8).
15. Unscrew the metal door stop P on the right-hand
side of the refrigerator's door, turn it over and screw
it to the left-hand side of the freezer's door, aligning
the hole in the plate with the one in the door ( R8).
Unscrew the metal door stop P on the right-hand
side of the freezer's door, turn it over and screw it to
the left-hand side of the refrigerator's door, aligning
the hole in the plate with the one in the door (R8).
16. Insert the hole cover O , previously placed on the
left-hand side of the refrigerator's door on the right-
hand side of the same door (R8).
17. Insert the freezer's door in the top hinge (R9).
18. Insert the middle hinge and screw it in place, chec-
king that the plastic distance pieces are correctly in-
serted on the pin (R9).
19. Insert the refrigerator's door into the middle hinge
(R9).
20. Insert the bottom hinge into the refrigerator's door,
checking that the plastic distance piece is correctly
inserted on the pin between the hinge and the door.
Screw the hinge in place. (R9).
21. Re-install the plinth.
22. Insert the upper covers .
23. Return the appliance to vertical position .
Wait two hours before restarting your
refrigerator.
Downloaded from www.Manualslib.com manuals search engine
L
N
O
26
EN
drawing R6
drawing R7
M
N
drawing R8
P
drawing R9