Electrical Safety - Black & Decker VB2010P Handbuch

ENGLISH

Electrical safety

#
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
the voltage on the rating plate.
If the supply cord is damaged, it must

be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Additional safety instructions for
vacuum cleaners
Before use, always make sure that

the filters are correctly seated. Do not
use the appliance without all filters in
place.
Do not carry the appliance at the

container handle.
Do not use the appliance to pick up

liquids.
Do not use the appliance to pick up

any materials that could catch fire.
Do not use the appliance near water.

Do not immerse the appliance in water.
Keep the motor draught away from

your eyes and face.
Keep children and animals at a safe

distance when using this appliance.
Always work from bottom up when

using the appliance on stairs, and
keep the appliance at least a stair
below your working position.
Always be aware of the position of

the power cord and hose while using
the appliance.
Do not use the appliance without the

suction head or another suitable
accessory mounted to the tube.
After use, fully rewind the power cord

and store the appliance in a tidy
manner.
Keep your hair, clothing and gloves

away from moving parts.
Do not use damaged accessories.

Use only Black & Decker accessories.

Features
This appliance includes some or all of the
following features:
6
1. On/off switch
2. Cord rewind button
3. Speed control selector
4. Handle
5. Hose
6. Airflow control switch
7. Extension tube
8. Suction head
9. Dust container
10. Wheels
11. Bin full indicator
In addition, this appliance is supplied with
some or all of the following accessories
(fig. A):
12. Crevice tool / Brush tool
13. Upholstery brush
14. Parquet floor head (VB2010P)
Assembly
Connecting the hose (fig. B)
Insert the hose connector (15) into

the inlet (16) of the appliance.
Push the hose until the release

buttons (17) click into place.
To disconnect the hose, press the

release buttons and pull out the hose.
Connecting the tube (fig. C)
Push the hose nozzle (18) into the

tube (7).
To remove the tube, pull the hose out

of the tube.
Mounting the suction head (fig. D)
The suction head (8) allows for
vacuuming on carpet and hard surfaces
(e.g. laminate and tiles).
Push the tube (7) into the head (8).

To remove the head, pull the tube out

of the head.
VB2010P - Mounting the parquet
floor head (fig. D)
The parquet floor head (14) allows for
vacuuming on wooden and polished
surfaces.
Push the tube (7) into the head (14).

To remove the head, pull the tube out

of the head.