General Safety Instructions - Cocraft LS5T Original Bedienungsanleitung

Wear protective gloves.
Wear non-slip safety shoes.
Switch off and unplug the product whenever it is not in use and before it is cleaned or serviced.
Warning: None of the safety devices on the product must be modified in any way.
Warning: Always work alone with the log splitter. Two people must not operate the log
splitter at the same time.
Warning: Never use the product in the rain or in wet conditions.

General safety instructions

1. Keep the working area tidy. Cluttered surfaces and benches invite accidents.
2. Do not use the machine in dangerous environments. The machine should not be used on moist or wet
surfaces or in rain. Make sure that the work area is well lit. When working in dusty atmospheres, make
sure that the air is adequately circulated. Do not operate power tools in explosive atmospheres, such as in
the presence of flammable liquids, gases or dust.
3. Avoid electric shocks. Avoid body contact with earthed or grounded surfaces such as pipes, radiators,
ranges and refrigerators when using power tools.
4. Keep children and bystanders away. Keep children and visitors at a safe distance from electrical machi-
nery/tools and electric cables in the workplace.
5. Store power tools out of the reach of children. When not in use, power tools should be stored locked
away in a safe place, away from children.
6. Do not force the machine. The correct feed rate makes the work better and safer.
7. Use the correct tool for the job. Do not force a tool to perform a task that it was not designed for.
8. Wear suitable attire. Do not wear any loose-fitting clothing, gloves, necklaces, bracelets or other jewellery
that can get caught in moving parts. Non-slip footwear is recommended. Wear a hairnet or similar if you have
long hair.
9. Always wear safety glasses. Normal glasses are not tough enough to withstand impacts. Use a dust mask
or dust filter when working in dusty environments.
10. Connect dust extraction equipment. If the machine is equipped with dust extraction equipment, ensure
that it is connected and used properly. Make sure to empty the dust bag regularly.
11. Do not abuse the mains lead. Do not carry the machine by its mains lead. Do not yank the mains lead to
turn the power off, pull the plug out instead. Make sure that the mains lead does not come into contact with
heat, oil, or sharp edges.
12. Secure the workpiece firmly. Where possible, use clamps or a vice. You can then operate the tool using
two hands. This is much safer than holding the workpiece in one hand.
13. Do not overreach. Make sure that you stand steady and balanced all times.
14. Look after your tools. Keep blades sharp and clean for the best and safest performance. Follow the instruction
manual's recommendations regarding lubrication and replacement of accessories. Inspect the mains lead regularly.
If it is damaged it should be replaced by a qualified service technician. Inspect all leads and cables regularly to check
for any damage. Make sure that the machine's handles and controls are clean, dry and free from oil and grease.
15. Turn the power off. Pull out the plug and push in the emergency stop button before servicing or changing
any blades, drill bits, cutters or sanding discs.
3