Senco DS522-18V Betriebsanleitung Seite 19

Bit slips off screw or screw is driven
at an angle
Fastener Jams
Feed system "sticks" or returns
slowly
Tool overheats
Pushing force becomes excessive
Battery will not charge
Tool front-end will not install onto
console
Tool front-end will not separate from
console
Tool slid forward during drive
Bit is worn or broken
Nosepiece is worn or damaged
Bit is worn or broken
Screw length/nosepiece position is
improperly set
Defective collation material
Nosepiece damaged or bent
Screw partially driven into collation
material then feed system released
Debris build-up on mechanism
Return spring is weak or broken
Bit sticking in collation material
Drive application requires too much
torque
Improper screw for application
CAM screw is loose or damaged
Debris build-up on mechanism
Defective battery
The collar is not turned to the full
unlock position
Foreign object stuck inside the
connection
Components in connector may be
damaged
The collar is not turned to the full
unlock position
Components in the connector may be
damaged
19
Hold tool firmly while driving
Replace bit
Replace or return to Senco autho-
rized service centre for repair
Replace bit
See p. 11
Use Senco branded fasteners for
optimum performance
Replace or return to authorized
service centre for repair
Remove jammed screw with fingers
or pliers and resume use
Clean mechanism
Replace or return to authorized
service centre for repair
Use Senco branded fasteners for
optimum performance
Always attempt to store screws
in cool dry place before use.
Overheated collation can get soft and
cause a delay in feed system return
Discontinue use for that application
Consider alternative fastener
Tighten or replace CAM screw
Clean mechanism
See p. 15 for battery error code
description
Rotate the collar to full unlock
position
Be sure that no objects or parts are
jammed inside the connection
Replace front-end assembly or return
to Senco Authorized service centre
for repair
Rotate the collar to full unlock
position
Return to Senco Authorized service
centre for repair
EN