To Insert And Remove The Battery; Prepare The Receiver Collar - Petsafe PRF-3004XW-20 Gebrauchsanweisung

Prepare the Receiver Collar (PIG19-10763)
Step
5
There are two sets of Contact Points that can be used on your receiver. Your Receiver Collar comes with the short
Contact Points installed. The longer Contact Points should be used on dogs with long hair. Tighten the Contact
Points using Test Light Tool (5A) one-half turn beyond finger tight. Check the tightness weekly.

To Insert and Remove the Battery

Note: Do not install the battery while the Collar Receiver is on your pet.
1. Remove the screws with
a Philips screwdriver.
2. Remove the Battery
Lid (5B).
3. Install a 9-volt alkaline
battery (5C).
4. Replace the Battery
Lid (5C).
5. Reinstall the screws.
Do not over-tighten
the screws.
Replacement 9-volt alkaline batteries can be found at
many retailers.
To Set the Correction Level
Read all steps before attempting to set the
Correction Level.
1. Remove the clear plastic cover with the edge of
the Test Light Tool to expose the Correction Level
Button (5D).
2. With the battery installed, press the Correction
Level Button and release when the Receiver
Indicator Light lights up (5E).
3. The Receiver Indicator Light will emit a series of
flashes representing the Correction Level.
4. Increase the Correction Level by pressing and
releasing the Correction Level Button within
5 seconds of the previous series of flashes.
5. After setting the Correction Level, replace the
cover to protect the Correction Level Button.
The Correction Levels increase in strength from 1 to 5. Pushing the Correction Level Button while the Receiver
Collar is on level 5 will cause the Receiver Collar to revert to level 1. Refer to the Function and Response Table to
choose the Correction Level that best fits your pet.
The Receiver Collar will emit a Warning Tone and vibrate whenever your pet enters the Warning Zone, no matter
what correction level the Receiver is set to. If your pet continues into the Correction Zone, and the Receiver Collar
is set to level 2 or above, he will receive a Static Correction. The Receiver Collar is equipped to automatically
increase the level of Static Correction the longer your pet remains in the Static Correction Zone if the Receiver is
set at level 2 or above.
The Receiver Indicator Light acts as a low battery indicator, flashing every 5 seconds when battery replacement is
required. Test your Receiver Collar at least once a month to verify that it is functioning properly and that it activates
the Boundary Wire.
Over Correction Protection
In the unlikely event that your pet "freezes" in the Static Correction Zone, this feature limits the static correction
duration to a maximum of 30 seconds. While the system locks out further static correction, the warning tone will
continue until the pet leaves the Static Correction Zone.
5A
5D
petsafe.com
5B
5E
5C
11