RS Pro FGA-1372 Bedienungsanleitung Seite 15

EFFICIENCY BOOSTING
This unit is equipped with "energy efficiency boosting" function, by adding water (2.5L max.)
to the water gate at the side of the unit, the energy efficiency can be elevated. The principle is:
while the machine is working, the condenser will be getting hot, if you add the water into the
unit after the unit has been worked for more than one hour, the water will cool down the
condenser, thus it consumes less power, i.e. saving energy.
1. Open the water
&
gate
NOTE
1. This efficiency feature by adding water is proposed to do after one hour operation and
the water should NOT be over 2.5L, otherwise, the "water full" indicator will light in red
and the unit will stop working. ☆ This action should only be performed while the power
s on, in order the "water full" alarm could work, also please pay attention on the water
level of the see-through window beneath the water gate.
2. In case the "water full" indicator is in red, please drain the water from the drain point at
the back side of the unit until the red light goes out. The unit should work again now.
IMPORTANT !
1. To prolong the compressor's life, after switch-off of the unit, please wait for 3 minutes (at
least) before re-switch.
2. The cooling system will switch off if the ambient temperature is lower than the set one.
The ventilation, however, keeps working on the set level. If the ambient temperature rises
above the selected level, the cooling will return to work.
3. This machine is equipped with ANTI-FROST function. While using the heating function
during low temperature, sometimes the heating will stop for a while in order to melt the
frost. As this occurs, just wait for the heating returns to work.
rspro.com
2. Fill the water (max. 2.5L)
please pay attention on
the water level of the
see-through window
beneath the water gate.
15
FIG.20
3. Place the water
gate into space