•
Low — the icon is displayed with the New WAP Message tone.
Note: Browser does not open if you are in a call, or in Emergency Mode, or in Call Out, or in message
editor, or PIN lock state, or switching to DMO.
Viewing WAP Messages
Procedure:
1 From the home screen, press the
2 Select Messages → WAP Box.
3 Select the required message.
4 Select Go to to view the message in the browser.
Call-Out
This feature allows you to receive Call-Out alerts. On receiving the Call-Out messages, the radio interrupts current
services and attends to the Call-Out alert without any further delay. After call-out alert has been cleared, the radio
exits Call-Out mode and reverts to normal mode. During Call-Out mode you are only able to receive Emergency
Calls.
Note: To read an entire Call-Out message, scroll down the screen by pressing the down
The length of the message is indicated by the vertical red bar on the left of the screen.
Figure 3: Call-Out Message
Note: This is a selling feature.
Related Links
CO Box
on page 61
Types of Call-Out Alerts
There are four types of the Call-Out alerts:
•
Normal Call-Out – an alert message that is sent by a dispatcher either to a single radio or to a group of radios.
•
Storm Plan – an alert message that is sent by a dispatcher to a group of radios. To raise its reliability, it is sent
several times. You are not able to respond to the Call-Out alert and any key press takes you to the information
phase.
•
Fallback Mode – an alert message that is limited only to voice communication. To initiate this type of Call-Out,
press a One-Touch key predefined by your service provider. It can be cleared manually.
Note: Fallback is only possible when the radio is in Local Site Trunking.
•
Test Call-Out – a special Call-Out alert that is sent by the dispatcher to test this feature. On receiving the Test
Call-Out, the radio plays a tone and displays Test Call-Out. To respond and clear the alert, press the Test
OKS
key.
OFT
key.
MENU
Features | 101
key.
NAVIGATION
| |
Send Feedback