Gdescription Of Control Panel; G1 Basic Controls; Hstarting; H1 Preliminary Checks, Adjustments And Operational Tests - Electrolux LIBERO POINT NERLP2 Installations-Gebrauchs-Und Wartungs

a path of minimum resistance for the electric
current, to reduce the risk of electric shock. This
product comes with a cable with ground wire
and ground pole. The plug must be connected
to a power socket properly installed and
grounded in accordance with the standards
and local regulations.
G DESCRIPTION OF CONTROL PANEL
Described below are all the single buttons and
functions present in the control panel on the
front of the hood (fi g. 3).
G1 Basic controls
Button S - On / Off
This button switches the appliance on and off
(press for about 2 seconds).
When the extraction fan is activated the
speed will automatically be set to the last
value selected before appliance shutdown.
Button T - Increase extraction speed
This button increases the appliance extraction
speed.
Button W - Decrease extraction speed
This button decreases the appliance extraction
speed.
Button U - Max. speed
Pressing this button increases the machine
extraction speed to maximum for a few
seconds.
Downloaded from www.Manualslib.com manuals search engine
Buttons V-X - Disabled buttons
The buttons shown are disabled.
Button Z - Switch on / Switch off refrigerated
drawer
This button switch on or switch off the
refrigerated drawers.
Button A1 - Adjusting temperature
refrigerated drawer
This button is used to adjust the temperature
of the refrigerated drawer.
H STARTING
H1 Preliminary checks, adjustments
and operational tests
H1.1 Electrical checks
Before starting the machine:
• Check the correct connection of the electrical
wires feeding the machine;
• Make sure the mains voltage and frequency
match the data given in Table 1;
• Make sure all the guards, safety devices
and emergency switches are in place and
effi cient.
H1.2 Component positioning check
• Check the correct positioning of the grease
trays and labyrinth fi lters in Zone A (par. B.2.1).
The fi lters must be properly positioned;
• Apply the brakes of the castors on the operator
side;
• Make sure that no objects obstruct the inlets
of Zone A;
• Remove the tray supports "
• Install the cooking appliances, connecting
them to the outlets "G", carefully following
43
F" (Fig. 1);