Selecting And Editing The Effects - Korg StageVintage SV-1 Anleitung

S
ELECTING AND EDITING THE EFFECTS
You can select the various effects and amp models by turning the corresponding
TYPE knobs. You can change the effect main setting by using the DEPTH,
INTENSITY, SPEED, DRIVE knobs. Deeper editing can be done through the
SV-1 Editor software.
Effects and the amp simulation can also be turned on or off by pressing the cor-
responding ON/OFF button. Changes can be saved, together with a sound, into
one of the eight FAVORITES locations.
We will experiment with the effects, by going from the beginning of the effect
chain, where the most mind-boggling preamp effects are located, to the end,
with the creamiest, most reassuring touch-up effects are contained. Just consider
this effect chain as the effect chain of a classic instrument amplifier.
NOTE: With some of the effects, the name of the actual parameter you will be edit-
ing may differ from what is printed on the piano panel. The name that appears in
the SV-1 Editor is the real name, as reported in the following tables. E.g., with the
Pre FX Compressor, the SPEED and INTENSITY knobs control the Sensitivity and Level
parameters respectively.
To turn each section on, press the corresponding ON/OFF button to turn its
1.
LED on. To turn the section off again, press the ON/OFF button again to
turn the LED off.
Using the SV-1 | Selecting and editing the effects – 23
Stereo Limiter
Stereo Mastering Limiter