General Troubleshooting - SPORTSTECH DESKFIT DFT200 Benutzerhandbuch

IF THE RUNNING BELT IS TOO LOOSE AND SLIPPING:
Turn on both sides the adjusting screws by a quarter of a turn clockwise, if necessary, adjust deviations as in
the above methods.
MULTI-V-BELT ADJUSTMENT:
If you use the treadmill for a long time, the multi-V-belt becomes loose due to abrasion, To ensure safe use,
you must make an adjustment.
If it appears during running, the so-called pause phenomenon is occurring, the multi-V-belt may be too loose,
and further adjustment is necessary.
If the belt can run freely, the tightness is appropriate.
If the running belt is halted, but the multi-V-belt and the roller are still running, it indicates that the running
belt is loose and appropriate adjustments must be made to ensure safe use.
If you notice that the running belt and the multi-V-belt are halted, but the motor is still running, it indicates
that the multi-V-belt is loose and appropriate adjustments must be made to ensure safe use.
PROBLEM
The device does not start
The running surface is slipping
The running surface is off centre
You hear strange noises
Short circuit or damage to the
power cable on the upper control
panel

GENERAL TROUBLESHOOTING

REASON
No power supply, or switch is on
'off'.
The treadmill's excess current
protection is not connected.
The running surface is loose.
The running surface is not adjusted
correctly.
The rotation axis requires grease.
Damage to the power cable on the
upper control panel.
34
SOLUTION
Connect power supply and switch
on the device.
Connect the excess current
protection.
Adjust the running surface accor-
ding to section 8. Maintenance.
Adjust the running surface to
being centred.
Apply grease to the rotation axis.
Tighten the appropriate screws.
Replace the lower control panel.