♦
Open the battery compartment cover
♦
Insert 2 x 1.5 V batteries (type AAA/Micro/LR3) (not supplied) into the battery
compartment
♦
Then close the battery compartment
ping it into place.
Handling and use
Switching the device on/off
As soon as the power supply via the mains cable
be in standby mode and the display
♦
Press the
on for the first time, the device starts in CD mode.
♦
Press the
device back into standby mode.
NOTE
►
After switching off, the device remains in standby mode.
►
Pull out the mains cable
periods, as the device consumes power even when in standby mode.
►
If you disconnect the device completely from the mains power and there
are no batteries in the battery compartment
time and the alarms and resave the radio stations later.
Setting the time
♦
Press the
by mode. The time can only be set while the device is in standby mode.
♦
Press the CLOCK/MEMORY button
flashes on the display
♦
Turn the −VOL+/ І◄◄ TUNE ►►І dial
12-hour display (in 12-hour display "PM" will be shown in front of the time
between 12 noon and midnight).
♦
Press the CLOCK/MEMORY button
♦
Turn the −VOL+/ І◄◄ TUNE ►►І dial
♦
Press the CLOCK/MEMORY button
♦
Turn the −VOL+/ І◄◄ TUNE ►►І dial
♦
Press the CLOCK/MEMORY button
NOTE
►
If no setting is made within 10 seconds while in setting mode, the device
exits the settings menu. All settings made thus far will be saved and the
display
GB │ MT
■
40
│
. Note the polarity diagram in the battery compartment
/SOURCE button
/SOURCE button
if you do not intend to use the device for long
/SOURCE button
.
shows the set time.
on the rear of the device.
by replacing the cover and snap-
is restored, the device will
shows "0:00".
to switch on the device. When switched
for longer than 2 seconds to put the
, you will have to reset the
if required to switch the device into stand-
until "24H" (24-hour display)
to select the 24-hour display or
. The hour flashes on the display
to set the hours.
. The minutes flash on the display
to set the minutes.
once to save the set time.
.
.
.
SCUR 3 A1