Beissbarth MS 80 Originalbetriebsanleitung Seite 42

en 42 | MS 80 | Operating instructions
!
WARNING! It is absolutely forbidden to carry out tire
inflation operations if the wheel is still mounted on
the machine!
!
WARNING! Very heavy wheels have to be moved by
at least two persons!
Mounting of agricultural wheels
1. Lubricate with mounting paste both tire beads, the
shoulder and the drop centre of the rim.
2. Operating the working arm movement control, re-
lease the working arm.
3. Bring the cover on the platform (lean it).
4. Put the tire on the rim, mount the special clamp (1)
on the front edge of the rim.
5. Operate the pedal to rotate the locking flange until
the clamp has locked the tire, lift the wheel and
bring the clamp at 12 hour.
6. While operating the tool movement control, rotate
the tool so that the disk faces the side of the tire
that has to be mounted and, by means of the same
control, lock the operating arm.
7. By activating the working arm shifting control, use
the bead breaking disk to press the tyre heel to-
wards the rim centre and, use the pedal, turn the
tightening flange until the rear heel has been moun-
ted completely..
8. Remove the clamp.
9. Introduce the tube (remember to lower the mandrel-
holding arm) and lean the wheel on the platform to
make mounting easier.
|
1 695 301 988 2011-04-04
10. Put the mounting tool close to the valve with the
special reference mark on the edge of the rim,
mount the clamp on the left of the mounting tool
whilst rotating the wheel clockwise and being sure
that the bead is in the drop centre of the rim.
i
If the mounting of the second bead should result
particularly difficult the pneumatic bead pressing
accessory can be used.
Mounting of wheels with bead wire
Bring the cover on the platform (lean it).
1. Bring the cover close to the rim by carrying out an
appropriate centring.
i
If the wheel has a tube, it has to be inserted in the
cover before mounting and it has to be deflated in
order to make it stretch uniformly inside the cover.
2. Use the bead breaking disk to carry out mounting of
the second bead.
1
3. Use the disk to insert the bead wire and then lock it
with the special locking ring.
i
If the tire is tubeless the special sealing ring has
to be inserted between the rim and the bead wire
(OR).
4. Put the valve in the special hole of the rim.
Beissbarth GmbH