Bimar VP58TA Bedienungsanleitung Seite 13

4) Attach the fan body (10) to the lower fixed rod (13) (pay
5) Couple the front grid (11) with the rear grid (12) and lock with the plastic ring
6) Extend the adjustable rod (8) to the desired height and secure by tightening the
7) Fix the fan to the base, then engage the column (5) to the lower column (4) so
8) The fan can also be used without
Downloaded from www.Manualslib.com
Fax +32 030 9904733
attention to the proper functioning) by plugging the hole of
the upper fixed rod (15) to the lower one, lock it by turning
the upper fixed rod counterclockwise.
and ensure the fastening with the appropriate locking screw (9), (the screw
must be in the lower part). Having done this, check that the protection grid is
firmly coupled and fastened to the motor.
fixing rod fastening screw (7).
that tabs and grooves collimate, and for motor locking counterclockwise until it
stops.
the lower fixed rod (4), remove the
lower rod from the base by turning
it clockwise, directly fix the upper
rod to the entire counterweight
base, locking it
counterclockwise direction.
Pannello comandi
A. Button 0-Off
B. Oscilattion
button
C. Button
On/Speed
D. Timer
button
manuals search engine
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
Complete fan
in a
Remote control
13 40
/
Assembly page 13/40
Fan with lower fixed
rod
A. Button 0-Off
B. Oscillation button
C. Button On/Speed
D. Timer button
E. Mode (normal,
natural, sleep)