Installation - Bimar VP58TA Bedienungsanleitung

Downloaded from www.Manualslib.com
Fax +32 030 9904733

INSTALLATION

• After removing the packing materials, check the integrity of the appliance; if you
are unsure, do not use it and ask for qualified professional help. The packing
materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach
of children because they are potential sources of danger. Attention: any stickers
or advertising material applied to the grid removed before using the appliance.
The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
• Before connecting the appliance, check that the voltage values shown on the data
plate correspond to those of the electricity supply network.
incompatibility between the electric outlet and the plug of the appliance, have the
outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the heater. In general, the use of adapters
or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must
not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
• To not place the appliance near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating
appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a
inclined plane (the appliance could upset).
manuals search engine
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
11 40
/
Assembly page 11/40
In the event of